RT 2010-2019 - 3D Printed Rear Trunk Holder
Sale

RT 2010-2019 - 3D Printed Rear Trunk Holder

SKU:
RTH3D-RT
USD34.95 USD19.95
(46 reviews)
Current Stock:
Adding to cart… The item has been added
Description

RT 2010-2019 - 3D Printed Rear Trunk Holder

Someone needs to come up with a solution to the cylinder that often fails at its job...Sometimes because it's got a few years of wear and/or because we over worked it. If you own a luggage rack you know what i'm talking about...With the heavy load of the luggage, you always need to hold it up when using the rear trunk, it will fall on you otherwise. If you have an older Spyder model, chances are that the cylinder is shot...tired....

This simple but effective design makes things so much easier and safer, once installed, open up your trunk lid and it will just stay open, to close simply lift lid a bit and push the rear trunk holder on the PUSH button to allow lid to close.

This will be a very economical solution for you and I bet for your friends, we all know someone with this issue. Installation will take you just a minute and will last the Spyder's life time.

Related Products

Reviews

  • 5
    3D printed rear trunk holder

    Posted by Ron Ferraro on 2022 Mar 25th

    Very easy to install and works great

  • 5
    Great Addition

    Posted by Scott Wells on 2022 Feb 7th

    This is a great addition to hold the trunk open. I used a silver marker to highlight the word push because I kept forgetting to push it. It works great to keep the trunk open especially when the wind is blowing.

  • 5
    RT series 2010-2019 - 3D printed rear trunk holder

    Posted by Russell HArt II on 2021 Dec 20th

    This is a wonderful product, I rally like that I don't have to prop something up, or use my shoulder to keep the trunk open.

  • 5
    Rear trunk holder

    Posted by John Anderson on 2021 Dec 6th

    Easy installation. Works as designed.

  • 4
    3D Printed Rear Trunk Holder

    Posted by Jerome Hobbs on 2021 Nov 25th

    Very simple product that works well. Holding screw is longer than it should be.

  • 5
    3D printed trunk lid holder

    Posted by Artie on 2021 Nov 20th

    This was an easy install and works great to hold open the lid on the back of my 17 Spyder RTL even with the rack on it.

  • 5
    3D printed rear trunk holder

    Posted by Ray H JOHNSON on 2021 Nov 2nd

    so happy with this new product. With the added trunk rack it was getting hard to have the trunk stay open. This addition works great and is an easy install. Highly recommend it.

  • 5
    3D printed rear trunk holder

    Posted by Randal on 2021 Oct 31st

    My cylinder was not holding on my 2012 RT Limited. Purchased this item to save money. It works just as advertised. I am very pleased. Just be careful when installing. Easy to drop and you will not be able to pull it back out..

  • 4
    Rear truck lid holder.

    Posted by Stanford Turner on 2021 Oct 31st

    Works perfect. Simple and effective. It could be some longer because the trunk lid will go up another inch to open wider.