Dual USB Charger For RT 2010-2019 & ST 2013-2016 (Blue LED)
USD34.95
Dual USB Charger for RT 2010-2019 & ST 2013-2016 (Blue LED)
This is a nice alternative to getting all your electronics charged while riding. It's a perfect fit in one of those available slots just beneath the steering wheel. Install in about 45 minutes if you take your time, you can actually just use the wiring behind the dashboard. Not recommended for a direct battery hook up because with the LED light always on it will bring down the battery. You're better off with the power coming on with a key activate power source.
-
-
Sale
RT 2010-2019 - Rear Trunk LED Light
USD34.95 USD19.95 -
-
Sale
Reviews
-
Dual USB charger
Fairly easy install - works and looks like an OEM accessory. Should be a stock feature on all Spyders, so this is a must-have in my book.
-
Dual USB Charger
Love these! Have a 6ft for my phone while riding in the back and a 1 ft to charge drivers phone while in the phone holder
-
Dual USB Charger for Spyder RT Limited
Followed video installations instructions to the letter, which made this a very doable self-installation product. The only thing I would recommend is getting rid of those cheap wire splices and replacing with Posi-Tap connectors. Overall, great product, using it daily to charge my iPhone, listen to my music and get GPS directions.
-
Dual USB Charger
Great product
-
Dual USB port....
well made, works great.
-
Dual usb charger
Installed . wire connections a little to bulky. Never used it yet.
-
Dual USB charger
Nice product but the video I rely on to install is on an older model with a different dash. Wish there was newer one. I have 2019 RT limited Admin.... please call i can help
-
Facile a installer
Très facile a installer. Peut s'installer en environ 30 min.
-
Dual USB charger.
With video for installing, and the one on removing the mirror, this was a piece of cake. The biggest install prob I had was the connections behind the dash. Mine seem closer than in the video. Cutting the hole for the unit was a bit scary,. What if I got it too big? I measured, cut, remeasured and carefully tried putting the unit in slicing bits off at a time. Finally, it slipped in snug and has worked fine. I’m able to plug my phone and gopro in at the same time. One negative. I have no idea how it could be resolved but if one got caught in a sudden downpour what would happen. Even with the cover in place, I’m not sure the cover would keep all the water out. Anyway, I’m mostly satisfied.