RT 2010-2019 - 3D Printed Rear Trunk Holder

RT 2010-2019 - 3D Printed Rear Trunk Holder

Someone needs to come up with a solution to the cylinder that often fails at its job...Sometimes because it's got a few years of wear and/or because we over worked it. If you own a luggage rack you know what i'm talking about...With the heavy load of the luggage, you always need to hold it up when using the rear trunk, it will fall on you otherwise. If you have an older Spyder model, chances are that the cylinder is shot...tired....

This simple but effective design makes things so much easier and safer, once installed, open up your trunk lid and it will just stay open, to close simply lift lid a bit and push the rear trunk holder on the PUSH button to allow lid to close.

This will be a very economical solution for you and I bet for your friends, we all know someone with this issue. Installation will take you just a minute and will last the Spyder's life time.